You may at some point in the production realise that you have programmed an unnecessary Lighting State or actors lines may be cut and so you will need to delete some memories.

Turn key to Program

Press Memory Section PREVIEW Button

Select the Memory you want to delete by pressing the memory + or minus buttons.

Put Master B to 0

Press and hold the PROGRAM MEMORY button until a small dot appears in the bottom right of the display.

Helpful Hint: Setting the Desk to Recovery mode

By setting the desk to recovery mode it means that if the power fails or power to the desk is cut then when power is returned the desk will automatically scene and setup at which it was when power failed.

Turn key to PRESETS ONLY

Enter Super User mode: To do this press and hold the Effects + and - buttons and turn the key to PROGRAM

Release the + and - Buttons

Find on screen Other Things by using memory + and - keys. Press the Program Memory button

On the screen it will probably say NO RECOVERY

Press the Program Memory Key again.

The Screen will now read: RECOVERY ON.

Turn Key to Presets Only

It is Now set in Recovery mode. Before performing this operation please check with your Teacher or Stage Manager.

When using the Board do not do anything you are unsure about just ask Your Teacher, SM or someone with reasonable Lighting Know How.

The equipment is very expensive so don't be to Heavy Handed.

Before touching the board make sure there is not a show programmed on there which you might mess about with.